Connecticut General Statutes 16-19ff – Submetering. Regulations. Application process
(a) Notwithstanding any provisions of the general statutes to the contrary, each electric distribution company shall allow the installation of submeters at (1) a recreational campground, (2) individual slips at marinas for metering the electric use by individual boat owners, (3) commercial, industrial, multifamily residential or multiuse buildings where the electric power or thermal energy is provided by a Class I renewable energy source, as defined in section 16-1, or a combined heat and power system, as defined in section 16-1, or (4) in any other location as approved by the authority where submetering promotes the state’s energy goals, as described in the Comprehensive Energy Strategy, while protecting consumers against termination of residential utility service or other related issues. Each entity approved to submeter by the Public Utilities Regulatory Authority, pursuant to subsection (c) of this section, shall provide electricity to any allowed facility, as described in this subsection, at a rate no greater than the rate charged to that customer class for the service territory in which such allowed facility is located, provided nothing in this section shall permit such entity to charge a submetered account for (A) usage for any common areas of a commercial, industrial or multifamily residential building, or (B) other usage not solely for use by such account.
Terms Used In Connecticut General Statutes 16-19ff
- Authority: means the Public Utilities Regulatory Authority and "department" means the Department of Energy and Environmental Protection. See Connecticut General Statutes 16-1
- Class I renewable energy source: means (A) electricity derived from (i) solar power, (ii) wind power, (iii) a fuel cell, (iv) geothermal, (v) landfill methane gas, anaerobic digestion or other biogas derived from biological sources, (vi) thermal electric direct energy conversion from a certified Class I renewable energy source, (vii) ocean thermal power, (viii) wave or tidal power, (ix) low emission advanced renewable energy conversion technologies, including, but not limited to, zero emission low grade heat power generation systems based on organic oil free rankine, kalina or other similar nonsteam cycles that use waste heat from an industrial or commercial process that does not generate electricity, (x) (I) a run-of-the-river hydropower facility that began operation after July 1, 2003, has a generating capacity of not more than sixty megawatts, is not based on a new dam or a dam identified by the Commissioner of Energy and Environmental Protection as a candidate for removal, and meets applicable state and federal requirements, including state dam safety requirements and applicable site-specific standards for water quality and fish passage, or (II) a run-of-the-river hydropower facility that received a new license after January 1, 2018, under the Federal Energy Regulatory Commission rules pursuant to 18 C. See Connecticut General Statutes 16-1
- Combined heat and power system: means a system that produces, from a single source, both electric power and thermal energy used in any process that results in an aggregate reduction in electricity use. See Connecticut General Statutes 16-1
- distribution company: means any person providing electric transmission or distribution services within the state, but does not include: (A) A private power producer, as defined in section 16-243b. See Connecticut General Statutes 16-1
(b) The Public Utilities Regulatory Authority shall adopt regulations, in accordance with the provisions of chapter 54, to carry out the purposes of this section. Such regulations shall: (1) Require a submetered customer to pay only his portion of the energy consumed, which cost shall not exceed the amount paid by the owner of the main meter for such energy; (2) establish standards for the safe and proper installation of submeters; (3) require that the ultimate services delivered to a submetered customer are consistent with any service requirements imposed upon the company; (4) establish standards that protect a submetered customer against termination of service or other related issues; and (5) establish standards for the locations of submeters. The authority may adopt any other provisions it deems necessary to carry out the purposes of this section and section 16-19ee.
(c) The authority shall develop an application and approval process that allows for the reasonable implementation of submetering provisions at allowed facilities, as described in subsection (a) of this section, while protecting consumers against termination of residential utility service or other related issues.